SuperlecDirect - ElectriciansForums.net Electrical Suppliers
This official sponsor may provide discounts for members

Discuss Looking to purchase a Trumpf laser table in the Industrial Electrician Talk area at ElectriciansForums.net

Welcome to ElectriciansForums.net - The American Electrical Advice Forum
Head straight to the main forums to chat by click here:  American Electrical Advice Forum

Hi,
Looking to purchase a Trumpf laser table that uses 90 amps and wanting to run from a 150KW diesel generator. Can this be done and if so, what would be required for a UPS? Thank you
 

UNG

-
Mentor
Esteemed
Arms
Your post is a liitle confusing do you have anymore information on the laser table and generator also how does the UPS fit into the setup
 
Hi, Sorry. The table specs are as follows:

Trumph TruLaser 3040
Watts 4,000
Type L32
Manufactured March 2012
Electrical Supply 460 V / 60 Hz
Full load current 90 Amps
Amp rating of largest motor 7.9 amps
Necessary fuse protection 3 x 160 Amp
Air supply 100 - 145 psi
Nitrogen supply 390 psi
Oxygen supply 210 psi


Have a 3 phase diesel generator that produces 150 KVA, 125KW

Looking to have the unit set up remotely where 3 phase power is not available.

Any help would be greatly appreciated. Thank you
 

Reply to Looking to purchase a Trumpf laser table in the Industrial Electrician Talk area at ElectriciansForums.net

Top