I have a redring water heater with a blown thermal fuse.Trying to keep all original wiring,sleeving etc.Finding it hard to source ferrules to crimp wire to thermal fuse.I have bootlace ferrules but they have the flared lip at one end.Where would I find a parallel ferrule like the type you find on wire ends inside domestic 3 pin plugs?Any help appreciated.
Discuss Parallel Wire end ferrules in the DIY Electrical Advice area at ElectriciansForums.net
Reply to Parallel Wire end ferrules in the DIY Electrical Advice area at ElectriciansForums.net
Similar Threads
Once again I am using the Engineering chat as I think my question is more theoretical rather than 'diy advice'. If I am misusing the forum...
Hello, I live in Mexico, where I have a small, un-official trailer park on my property.
The property is serviced by my privately owned, 650amp...
TLDR: In a 3 wire service are the ground and the neutral always bonded, in all subpanels?
House made in 1970 has the meter and a 150 amps breaker...
- Locked
- Sticky
Beware a little long.
I served an electrical apprenticeship a long time ago, then went back to full time education immediately moving away from...
One for the more 'experienced' out there...
When was this available?
To 1363 apparently at the time, but without the sleeved pins...
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.