Discuss Safety! Am I really that old??? in the UK Electrical Forum area at ElectriciansForums.net

Wrapping tape round a bad cut is probably the best thing you can do because it compresses the wound and stops it bleeding. Have always done it. Was putting a Bosch speed spade bit through a bit of pic window board last year when it snatched, jumped, and landed square on a finger nail. Gritted teeth, shoved the apprentice out of my way and tightly wrapped it, and the pain was gone within seconds. It's brilliant.
keep a roll of this in the van

effb595522114eff643318cdf7f7183b.jpg
 
The problem is actually that the H&S laws are destroying the trade and infact society in general. Of course safety should be a personal issue.

The ONLY people that benifet from the H&S laws and requirements are those who have manufactured work for themselves by creating them and the businesses who have jumped on the band wagon created by it. The general worker who is sensible and trained is hampered by the restrictions enforced upon him, the 'newby' or trainee into the trade is denied the right to be responsible for himself and enforced to rely on the requirements, they will never be granted the chance to apply common sense and as a result will be hampered by it. The businesses are ladened with the burden of the responsibilities and threats and last of all the customers/public are ultimately the ones who have to foot the cost.

I may be a dinosaur but I have been around the block a time or two and in my time in the trade I have trained many, many apprentices and employed many good men. But as a small business I will now NEVER employ or train again purely because of the H&S implications, and i certainly aren't the only one.


...I have to disagree,fella...

I am not unaware of risk,my work has involved me in areas,where injury and death,have occurred.

I have worked,in places on this planet,where safety has proved absent,and concern over the death of a work colleague,is not shared by employers,if they do not share a similar race or religion.

My hobbies have included motocross,banger racing,dead-lifts,para motoring and the regular partaking and organising of most forms of shotgunning.

In short,i like to think i'm a bus ride from being fairy-like...

...But if you truly believe,that HSE safety law and practice,in this country,has not benefited a multitude of folk,including all on here...i despair...
 
...I have to disagree,fella...

I am not unaware of risk,my work has involved me in areas,where injury and death,have occurred.

I have worked,in places on this planet,where safety has proved absent,and concern over the death of a work colleague,is not shared by employers,if they do not share a similar race or religion.

My hobbies have included motocross,banger racing,dead-lifts,para motoring and the regular partaking and organising of most forms of shotgunning.

In short,i like to think i'm a bus ride from being fairy-like...

...But if you truly believe,that HSE safety law and practice,in this country,has not benefited a multitude of folk,including all on here...i despair...
i dont think any of us here disagree with health and safety as such just how overboard it is.


why do we need to wear a hi-viz, hard hat glasses and gloves to connect a socket on a site?

step laders are banned and i for one believe its made it more dangerous.

ppe should be recommended and manditory in certain areas but not all as a matter of course.

education rather than protective measures as the primary safety precaution.


if im using a knife ill cut away from me, ill keep my hands and feet away from where im drilling or cutting.

ill even wear glasses/goggles as and when needed (not always needed when drilling especially when drilling down (depending on materials) etc
 
The problem is actually that the H&S laws are destroying the trade and infact society in general. Of course safety should be a personal issue.

The ONLY people that benifet from the H&S laws and requirements are those who have manufactured work for themselves by creating them and the businesses who have jumped on the band wagon created by it. The general worker who is sensible and trained is hampered by the restrictions enforced upon him, the 'newby' or trainee into the trade is denied the right to be responsible for himself and enforced to rely on the requirements, they will never be granted the chance to apply common sense and as a result will be hampered by it. The businesses are ladened with the burden of the responsibilities and threats and last of all the customers/public are ultimately the ones who have to foot the cost.

I may be a dinosaur but I have been around the block a time or two and in my time in the trade I have trained many, many apprentices and employed many good men. But as a small business I will now NEVER employ or train again purely because of the H&S implications, and i certainly aren't the only one.


I don't even know where to begin with this nonsense. It's like reading the Daily Mail. You're completely misrepresenting H&S law and its purpose. In fact, the law very rarely bans or otherwise prohibits specific items or practices. HASAW, as far as employees are concerned, really only addresses three issues.

1. That you take care of yourself and others affected by your acts and ommissions. Seem unreasonable to you?

2. That you cooperate with your employer in enabling him to discharge his legal obligations. In other words, your employer, not unreasonably, is expected to look at the tasks his employees carry out and write a process for doing so. They, in turn, have to cooperate with that. Terrible, eh?

3. That you do not interfere with anything provided for your health or safety. Don't cut the insulation off your screwdriver.

Now, we could look at various stautory regulations, but we'd find the same kind of language there. The problem, in my view, is not the law, it's interpretation of the law. It's about sensibly applying what's in front of you, and on the whole that's exactly how the law applies. Do some employers over emphasise some aspects of it? They surely do, but the problem is not the law, it's them. Frankly, how much good has been done by the introduction of H&S law isn't even a subject for debate. It's unarguably successful, using any measure. Here's the thing though; although some small businesses may be squeezed to the extent that they fail, if they can't keep their workers properly safe, then arguably they should fail and society will benefit as a result.
 
i dont think any of us here disagree with health and safety as such just how overboard it is.


why do we need to wear a hi-viz, hard hat glasses and gloves to connect a socket on a site?

step laders are banned and i for one believe its made it more dangerous.

ppe should be recommended and manditory in certain areas but not all as a matter of course.

education rather than protective measures as the primary safety precaution.


if im using a knife ill cut away from me, ill keep my hands and feet away from where im drilling or cutting.

ill even wear glasses/goggles as and when needed (not always needed when drilling especially when drilling down (depending on materials) etc



"why do we need to wear a hi-viz, hard hat glasses and gloves to connect a socket on a site? " You don't, unless the site management says you do. It's their site, and only they can decide what level of PPE is appropriate. The law plays no part in that. Personally, I find a blanket requiremnt for high-vis strange, but it's not my call, and certainly isn't required by law.


"step laders are banned and i for one believe its made it more dangerous." You have my attention now. Where exactly are stepladders banned? Certainly not in law. The Work at Heights Regs even allow for use of ladders and stepladders as a working platform for limited periods. I can assure you that the guys I work with regularly use stepladders every day.

"ppe should be recommended and manditory in certain areas but not all as a matter of course." Again, PPE isn't necessarily a legal requirement, although it usually makes a degree of sense. In some instances, it woud be madness not to use it. The PPE at Work Regs don't really require the use of PPE unless risk assessment demands it. They're more about selection, provision and traing surrounding PPE.

While I do understand your argument, that argument isn't with the law, it's with those responsible for its application.


Edit: Found this: Myth: HSE has banned stepladders. Ban on stepladders? I think not.

Also this: http://www.hse.gov.uk/myth/myth-busting/2012/case093-hivis.htm
 
Last edited by a moderator:
totally agree.common sense should dictate what ppe should be used and when to use it. unfortunately a lot of employers and site management buffoons insist on blanket use of unnecessary ppe because they don't possess any common sense.
 
I think what's behind it is this: regulations pretty much leave it up to the individual to assess rsik and make a decision as to what preacutions, PPE etc. to use. Employers get nervous about that, so they, in writing processes, become prescriptive. For example, while the Work at Heights Regs talk about falling a distance liable to cause injury, employers will try to prescribe what that distance is. It's understandable in a way, but doesn't always make sense to everyone. The alternative, of simply ignoring regulations, seems far more frightening to me.
 
I don't even know where to begin with this nonsense. It's like reading the Daily Mail. You're completely misrepresenting H&S law and its purpose. In fact, the law very rarely bans or otherwise prohibits specific items or practices. HASAW, as far as employees are concerned, really only addresses three issues.

1. That you take care of yourself and others affected by your acts and ommissions. Seem unreasonable to you?

2. That you cooperate with your employer in enabling him to discharge his legal obligations. In other words, your employer, not unreasonably, is expected to look at the tasks his employees carry out and write a process for doing so. They, in turn, have to cooperate with that. Terrible, eh?

3. That you do not interfere with anything provided for your health or safety. Don't cut the insulation off your screwdriver.

Now, we could look at various stautory regulations, but we'd find the same kind of language there. The problem, in my view, is not the law, it's interpretation of the law. It's about sensibly applying what's in front of you, and on the whole that's exactly how the law applies. Do some employers over emphasise some aspects of it? They surely do, but the problem is not the law, it's them. Frankly, how much good has been done by the introduction of H&S law isn't even a subject for debate. It's unarguably successful, using any measure. Here's the thing though; although some small businesses may be squeezed to the extent that they fail, if they can't keep their workers properly safe, then arguably they should fail and society will benefit as a result.

everyone has their own opinion, but with an opinion, knowledge and language like that I can only assume you are one of those who work in the world of H&S and benifet greatly from the nonsense it incurs. It's certainly not the real world and can only assume your not a self employed spark. (No offence intended)
 
everyone has their own opinion, but with an opinion, knowledge and language like that I can only assume you are one of those who work in the world of H&S and benifet greatly from the nonsense it incurs. It's certainly not the real world and can only assume your not a self employed spark. (No offence intended)

No, you're right. I'm not a self employed spark, but is that really relevant? You're welcome to your assumptions, but they're meaningless. This is not about opinion. Everything I've stated as fact is verifiable. I spent a lifetime on the tools until around 8 years ago, when I became a trainer. It's certainly true to say I've seen a different side to the world since, but again, that can only add to the sum of my experience. perhaps if you had spent some time in investigating accidents and their causes, you might feel differently too. The law is not the enemy here, misinterpretation, on all sides (and some of the frankly ignorant comments on here confirm this), is.
 
Last edited by a moderator:
The laws and lunacy they incur are certainly my enemy. But we'll agree to disagree.
I'll continue to tow the line where I HAVE to, I'll flaunt them when I NEED to.
 

Reply to Safety! Am I really that old??? in the UK Electrical Forum area at ElectriciansForums.net

Similar Threads

Hi everyone :) my first post here. Quick background I'm a newly qualified installer of somewhat advanced years whose just starting out in the...
Replies
12
Views
1K
Hello all, I've just been perusing the AM2/E/S threads on here. Thought you might like a bit of a review. If, like I did, you find yourself...
Replies
7
Views
2K
I know how I was taught to test a RCD, 6 tests in all two no go, two under 300 mS and 2 under 40 mS with no load. But thinking about it not so...
Replies
7
Views
3K
When I bought my house we had it inspected before buying to highlight faults, so the inspection and testing done by RICS Chartered Surveyor and...
Replies
13
Views
3K
Hi Just getting started with a view to DIY electrics on my house extension in a few months time, and ideally would like to map out the current...
Replies
8
Views
2K

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

This website was designed, optimised and is hosted by untold.media Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock