Self Cancelling Turn Signal "Noise" (Motorcycle)

[ValkyrieJosh]

Please bear with me as I lay this out..

What are we dealing with?
- Motorcycle
+ I recently installed a plug-n-play self cancelling turn signal module. There is a power supply, ground, and the rest plugs into the existing wiring harness.
Operation of self cancelling module
- The module can be programed by rapidly pulling the brake lever 5 times to enter the program mode.
- The turn signal indicator flashes to acknowledge when it goes into program mode.
Issue
- While at higher speeds the indicator randomly flashes, and will go into program mode itself.
- If other electronics are used (like the horn) the indicator flashes.
Question
- Is there a way to isolate the self cancelling turn signal module?
+ If so, please advise on components, re-wire suggestions, etc

Thank you in advance!

 

[plugsandsparks]

I think it may be a vibration issue. suggest remove connection to brake lever wiring and do the programme mode manually.

 

[static zap]

I think it may be a vibration issue. s

Vibration and maybe air pressure.
(though following my son on his 125 he was always activating the brake pedal with his feet a little ! )
If multiples switches on same circuit -Could try measuring volts across switch as hit other brakes !
If brake is not required in normal operation of clever uniit --
break the link between brakes and the module as @plugsandsparks arks suggests.