Splitting an Sigle RCD board

[spark 68]

One other point,

You will need the incoming feeds (L and N incoming) for the RCD's at the same side, this is usually the top side, where the busbars fit in the bottom, and your N cables to the N bars (outgoing side) from the same side as the busbars.
If that makes sense.

 

[nrg]

Yes I know what you mean. Yes that's all covered thanks again

 

[sparks1973]

Yes I know what you mean. Yes that's all covered thanks again

and dont worry about me either....i was just being sarky....