What do you lot think to this one??

[grantr37]

would like to say what I think but no doubt said legal professional will be reading this forum and may take offence and try to sue...

 

[S.I.Electrical]

Good luck with getting that passed through the courts and an insurance payout + the complete new install before march...

It all goes to court on the 30th of this month as far as I know mate

 

[S.I.Electrical]

I think rather than writing out a report in a letter I will fill out the Electrical Installation Condition Report form and put the photo's with it and see what happens. I phoned up our Napit inspector last night and he said just fill the form in and back it up with the photo's but take it to a far end of a fart and list everything.

 

[markc123]

Good plan S.I, when you've done you should post the EICR on here for everyone to have a good laugh at how much it failed by. Then publically hang the sparks involved off the whitby swing bridge - if it doesn't fall into pieces by then :38:

 

[bigbaddave]

I thought that breaker was for "foof on roof"

 

[Robotstar5]

I think you're going to need a secretary to do all the writing/typing

 

[GLENNSPARK]

but this is it....you dont waste time going through each circuit on a board like that...just fail it all....
then give him a price for remedials...
look, i`m not in the habit of just failing stuff here n there...far from it....in fact i will look for any way i can (as far as is reasonably practicable) to pass an existing install...or if its a case of a bit of tidying up here n there..then so be it...a (3) if you like...
but that board is a load of old b0ll0cks......
most of the other stuff can just be resited outside the zones....

 

[bigbaddave]

I like the fan isolator in the shower.. Im going to do this at home

 

[bigbaddave]

but this is it....you dont waste time going through each circuit on a board like that...just fail it all....
then give him a price for remedials...
look, i`m not in the habit of just failing stuff here n there...far from it....in fact i will look for any way i can (as far as is reasonably practicable) to pass an existing install...or if its a case of a bit of tidying up here n there..then so be it...a (3) if you like...
but that board is a load of old b0ll0cks......
most of the other stuff can just be resited outside the zones....

I agree with this one, Bit of a waste of time testing everything. Its a fail regardless

 

[markc123]

issue a PAT fail sticker to take the pee