Bulk Workwear - Clothing Suppliers for the Whole Forum Network
This official sponsor may provide discounts for members

suspended

  1. P

    Switching of suspended dimmable led fittings

    Hi, I am installing 12 x suspended LED fittings in an office. They are on two switches. The fitting itself comes with a 5 core cable. How do I switch this. Do I need on/off and momentary switch or something else. See attached pic. Any ideas gratefully accepted.
  2. T

    Re suspended ceilings thread and the mess in it, before and after

    Just a little update as @marconi expressed it may be interesting to see before and after on sargasso sea of cables above ceiling.
  3. H

    Suspended lights fitting ideas

    Getting a stack of these to replace the fluorescent we currently have in our sports hall. I've got a test unit, and I've put it up using the suspension kit the old light was on - it's a wire type with a quick release mechanism. The new light weighs the same as the old fitting so the wire...
  4. J

    Can incoming mains run above ground under suspended floor?

    Hi all. I'm looking for some expert advice on the above. I am having an extension built and the footings are a raft slab which can be built/poured under the existing incoming mains cable (it's in a black pipe approx 50mm dia). There will be a suspended floor approximately 100mm above the...
  5. EcoTechnologies

    Installation above suspended ceiling issues

    Hey guys Got called to a job where the entire installation was fed above a suspended ceiling on a commercial premises wired a few years earlier. All the cables are draped across the ceiling grids, all light fittings not double insulated and made off poorly with the possibility for the grid to...
  6. M

    How much would you charge to install RGB LED strip lighting?

    Hi all, I have two rooms with suspended ceilings in which I need to run 25 metres of RGBW strip lighting in (RGB plus Cool White) plus another 15 metres of the same in another room (please see pictures). Both circuits will include 2 drivers, 1 controller and 1 amplifier. This will all be...
  7. Adie moore

    emergency lights

    finished a job a little while ago for a builder who was refurbishing a male and female toilet. the existing lunch box running man em lights were replaced (as per customer specs) with recessed led em lights, one above the exit door and one in the centre of the room. I received a call today from...
  8. G

    E27 ceiling rose...

    Customer has bought a shed load of decorative led lamps, thing is they're all E27, and they currently have standard roses with BC fittings. Where can I get the E27 fittings, so I can discard the BC and replace with E27? Had a quick google and can't see anywhere, bar China, that do them...
  9. M

    Commercial Tips on how to remove the Clear Light Diffuse suspended ceiling Florescent light fitt

    Hi, I need tips or links on how to remove the Clear Prismatic Light Diffuse from suspended ceiling Florescent light fittings the size is 595 x 595, I am unable to lift the units and remove from the side due to a new air duct installed directly above all 4 fittings which are in a Hallway about...
Top Bottom