10mm earth bond

[mcm]

is it ok to through crimp 10mm earth bonding cable due to relocation of board. would re run new cable but under tilled floor. thanks

 

[jaresquire]

Yes, just test that the 0.05 ohms or better is still achieved.

 

[ACL]

A through crimp is considered a permanent joint so it would be ok. I would sleeve it with some form of green & yellow, either some heat shrink or insulation tape.

 

[Canttouchthis]

Yes that's fine and as it's a permanent connection it doesn't need to be accesable either as through crimp is a perm connection

 

[Benn]

I was under the impression that you could not joint bonders?

 

[telectrix]

that's when using 1 cable to bond gas and water, that you dont break it because then mr. plumber disconnects the gas bond and he's also disconnected the water as well.

 

[grimysparks80]

could you join it with a henley connecter block providing it was accessible?
ie 1 cable up under the floors then 2 going off to gas and water?

 

[Spudnik]

No.......