Hello,
I would like to run a custom electronic engine control unit on one of my vehicles and to avoid cutting up the factory wiring harness. To do this I have found a 60 pin ECM plug from a breakout box and would like to connect the pins to flying leads. These leads would then go to the new control unit. I would like to connections to be robust and to be resistant to vibration.
What is the best way to do this? I'm attaching photos of the plug I plan to harvest. If there are any non-soldering methods I would be open to this. The gauges of the wires attached to the plug will vary from 14 gauge (ground wire) to 20 gauge.
Thanks!
I would like to run a custom electronic engine control unit on one of my vehicles and to avoid cutting up the factory wiring harness. To do this I have found a 60 pin ECM plug from a breakout box and would like to connect the pins to flying leads. These leads would then go to the new control unit. I would like to connections to be robust and to be resistant to vibration.
What is the best way to do this? I'm attaching photos of the plug I plan to harvest. If there are any non-soldering methods I would be open to this. The gauges of the wires attached to the plug will vary from 14 gauge (ground wire) to 20 gauge.
Thanks!