- Reaction score
- 25,440
It would not have been considered.
Discuss EICR 100ma RCD TT systems in the Periodic Inspection Reporting & Certification area at ElectriciansForums.net
To me that is the key factor - some additional clamping so tails being wagged does not result in them loosening from the incomer, and the entry glands seem the perfect way of dealing with that and the risk of insulation being cut on the case edge.
Also said incomer's screws correctly tightened. And checked after a wiggle.
Even so, if it were me I would still like to see a 100mA delay RCD up-front even with an all RCBO board to eliminate a single point of failure in the electronics.
Reply to EICR 100ma RCD TT systems in the Periodic Inspection Reporting & Certification area at ElectriciansForums.net
Similar Threads
Good Afternoon All
Currently doing an EICR on common parts of a big site with multiple blocks.
All blocks have outside garden spike lighting in...
Hello
Need to replace a distribution board in the next few weeks to allow for more circuits to be installed in January.
Existing is a TT system...
I'm practising EICRs on friendly locations as I'm still in training - technically done my 2391-52 but frankly need loads more practise.
I've just...
Carrying out a EICR in a commercial setting. In the main intake room the DNO supply comes in and it states clearly this is a PME system. 5 years...
Hello there. I've been looking around here and found some conflicting information. I have a question if I may ask. I had an electrician come over...
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.