How to bodge up a deliberate mistake

[telectrix]

I'll go with the bus bar cut short.

is that your new hair style, cut short?

 

[Mike Johnson]

You can't cut short what you haven't got.

 

[telectrix]

solvol autosol. used to use it on the aluminuim casing on motorbike. shone like the moon.

 

[Mike Johnson]

Yes I think my Grandfather used that.

 

[Soi disant]

but that 25mm? bit of tail is just linking 2 MCBs that have no L feed.

No, it runs from the outgoing main switch L to the infeed of that B32.

But it really begs the question "why?" as there are surprisingly few circuits for that size of CU and one wonderes what the 32A non-RCD feed with two cables was needed for.

My money is on a board change from a Wylex standard, sparky had stocked up on a few of those CUs when his wholesaler had them on a FGS-won't-somebody-buy-them offer, he didn't do any testing first, when he found that the RCD was tripping he hurriedly moved the neutrals, hacked the end off the busbar, bunged in that bit of tail and rode off home for tea.

UNLESS there is an earth fault on the RFC....

Roll up, roll up, place yer bets....

Also seem to be not enough neutrals conductors?

Looks that way. Must be a camera angle thing though?

 

[telectrix]

was he bald as well?

 

[Mike Johnson]

Don't know he always had his Trilby on, or was it a Fedora.

 

[telectrix]

fedora or kia-ora? mate of mine wore a steston , mind you, he was a bit of a cowboy.

 

[Bob Geldoff1234]

The breaker fed via the double covered tail is not RCD protected.This will be a case of a fault on this circuit that kept tripping the RCD so the 'electrician' bodged the wiring so that the circuit stays on when he changed the consumer unit rather than fault find the circuit.

 

[Dave OCD]

solvol autosol. used to use it on the aluminuim casing on motorbike. shone like the moon.

I still use it now Tel, mainly on stainless steel exhaust downpipes , it's still about the best one out there.