Pull cord Light In Bathroom Help

[John-S]

I am looking to change my Bathroom Light to motion sensor one.
It's switched on by pull cord (intending to remove pull cord part and leave on)
I wired it all up and tried it
Light stays on .. all the time (see just under the door) but if you go into bathroom and stay still light will go out but will emit slightly so not fully out then when you move it will come on.
Close the door and stays on ???

As you can see in pictures the existing wiring (3wires) and the new fitting.
Please if anyone can help what have I missed.

 

[Admin]

Sounds like its off state isn't fully off. Were their any instructions with it at all?

 

[John-S]

Sounds like its off state isn't fully off. Were their any instructions with it at all?

 

[John-S]

As you can see before disconnecting wires in previous picture there are 2 live wires connected in a connecting block
Guessing a neutral from pull cord

 

[westward10]

I assume the first pic with the light connected is the original light?
What colour wires are at the pull cord switch.

 

[John-S]

Yes the wiring connected is the old unit. I didn't check the pull cord one. Give me 5 mins will have a look

 

[John-S]

Council wiring for you.
Is this ok

 

[westward10]

Can you show how the new light is connected.

 

[John-S]

Blue with white sleeve is a live. Red and brown just on black as per old one

 

[John-S]

Not the best job but will tidy it once solved

 

[Aaron b]

I would have thought the cables in the terminal block was the permanent live and the blue with tape was the switched live. Are there any knobs or dip switches to make adjustments?

 

[John-S]

No nothing I just took the way wiring was in old unit and did like for like

 

[John-S]

See the beetle inside pull cord fitting

 

[John-S]

How would you wire it?
Incase I have did it wrong

 

[westward10]

It appears to be connected as the original so you may have a faulty fitting or it is not set-up correctly.