- Reaction score
- 203
Hi Guys/Girls
I've installed recently Texecom premier elite 24, very basic setup:
1 door contact, 3 PIR's downstairs and 1 PIR upstairs all wired DEOL and set as Area A (B is reserved for garage), 1 keypad, 2 external sounders, SmartCom module, all works fine but need bit of advise on programming.
Basically i need it to Part arm 3 itself at say 00:00 and disarm at 05:00 but - as my better half worries that if she comes downstairs half a sleep and alarm starts beep she may not disarm it on time - so it also need to deactivate itself if motion is detected on upstairs sensor.
I guess all that can be achieved using custom outputs but i cant get my head around it.
I've manage to set it up like that using SmartCom app and recipe but did not have time to test it fully.
But i prefer to set it in Wintex so is coded to panel.
Any help would be much appreciated...
I've installed recently Texecom premier elite 24, very basic setup:
1 door contact, 3 PIR's downstairs and 1 PIR upstairs all wired DEOL and set as Area A (B is reserved for garage), 1 keypad, 2 external sounders, SmartCom module, all works fine but need bit of advise on programming.
Basically i need it to Part arm 3 itself at say 00:00 and disarm at 05:00 but - as my better half worries that if she comes downstairs half a sleep and alarm starts beep she may not disarm it on time - so it also need to deactivate itself if motion is detected on upstairs sensor.
I guess all that can be achieved using custom outputs but i cant get my head around it.
I've manage to set it up like that using SmartCom app and recipe but did not have time to test it fully.
But i prefer to set it in Wintex so is coded to panel.
Any help would be much appreciated...