Aritech CS450 "Trouble" light on keypad

[Peter Morgan]

I have a Aritech CS450 which has been working fine for a number of years. All of a sudden the "Trouble" light came on the keypad.
I checked the logs and it showed "Fuses", so I checked the fuses - all ok
did a walk test - all ok
Tried an engineer reset - no different - light still on


The system seems to work as normal. i.e alarm trips if set and external sirens go off etc.

Anyone have any other ideas as to what my problem may be?
Thanks in advance.....

 

[Charlie_]

Have you cleared the logs?

 

[telectrix]

battery past it's useful life???

 

[Peter Morgan]

battery past it's useful life???

Thanks for the prompt reply.. replaced the battery about a month ago, so hopefully that shouldn't be an issue

 

[Peter Morgan]

Have you cleared the logs?

Thanks for the prompt reply... How do I do that? In the user manual it just says :-
"The Engineer Log can store up to 150 events. It is
not deleted by an arming."
and
I can't find any reference to clearing this log in the user manual.
The operator log shows nothing as "stores up to 10 alarms and
faults that occurred since the last arming." and there have been no faults/alarms since the last arming.

 

[Strima]

Has the battery been checked and also the system voltage to the battery?

 

[Charlie_]

When you go into the engineer log there is options to view log and also to delete log

 

[telectrix]

When you go into the engineer log there is options to view log and also to delete log

that's if OP has the eng.code.

 

[Peter Morgan]

Has the battery been checked and also the system voltage to the battery?

Thanks for this suggestion.... I'll check that!

 

[Peter Morgan]

that's if OP has the eng.code.

Hi, I have the Eng code but the only options are "Eng.Log/Time/Date". There does not appear to be an option to delete - see attached screenshot.

 

[Charlie_]

Is that from the user manual or the install manual?

 

[Peter Morgan]

Is that from the user manual or the install manual?

Sorry for the delay in replying.... it is from the User manual. I do not have the installation manual

 

[Peter Morgan]

Thanks for this suggestion.... I'll check that!

Hi... sorry for the delay in replying. I've check the supply to the PCB panel and there IS ~19vac there as per circuit diagram.