Hi there, my first post on this site, but i regulary read the interesting posts from others.
Does anyone fit the cheaper plastic consumer units?
I fit them from time to time as required in my current position but i was wondering what anyone else does to maintain the IP rating when using the pre-formed knockouts on the sides of these consumer units for the tail entry?
I was used to fitting metal clad only with a gland in my previous employment, so these are a bit of a come down for me in terms of quality.
Thank`s for any replies/suggestions
Does anyone fit the cheaper plastic consumer units?
I fit them from time to time as required in my current position but i was wondering what anyone else does to maintain the IP rating when using the pre-formed knockouts on the sides of these consumer units for the tail entry?
I was used to fitting metal clad only with a gland in my previous employment, so these are a bit of a come down for me in terms of quality.
Thank`s for any replies/suggestions