- Jan 27, 2019
- 54
- 7
- 83
- If you're a qualified, trainee, or retired electrician - Which country is it that your work will be / is / was aimed at?
- United Kingdom
- What type of forum member are you?
- DIY or Homeowner (Perhaps seeking pro advice, or an electrician)
Hi, everyone.
I need to move a circuit to an MCB at the other end of a split load board.
The cables all enter the CU at one end, and the cables in question will not reach the breaker at the other end without extending them. It is a ring final circuit.
What's the best method to do it? I was going to use in line crimps with heat shrink over. Would that be OK?
Any advice appreciated
I need to move a circuit to an MCB at the other end of a split load board.
The cables all enter the CU at one end, and the cables in question will not reach the breaker at the other end without extending them. It is a ring final circuit.
What's the best method to do it? I was going to use in line crimps with heat shrink over. Would that be OK?
Any advice appreciated
