Discuss Garage electrics help needed please in the UK Electrical Forum area at ElectriciansForums.net

Lanky, when I said I'm new to the trade, I'm an apprentice only a few months in so have next to no experience.

Specialist, the 2.5 supply is taken from the loads side of the 100amp isolator.

No worries lad, it was worded as if you were an electrician but had never done any domestic installs. With the amount of chancers we get around here, i was just probing. Stick your apprenticeship out and tell your mate to get a Qualified electrician in not a trained monkey. Might be a chance for you to watch and learn from the bloke putting the abortion right.
 
Nope, I get a competent electrician in, and take the original bod to small claims and inform the industry policing regulator.....oh yeah, remember now, we haven't got one :(
 
Just been to speak to him, the man charged him £230 for the work.

He asked for a cert so he is dropping one around in the morning??

Also I looked again in the electric cupboard where the meter is and the 100a isolator, it looks like he has cut the main Earth coming from the western power supply and put it in a connector block, then taken a new 10mm earth to the 100a isolator so he has an earth there for his 2.5 twin and earth cable to supply the shed. I've read that the main Earth can't be cut and should be continuous??
 
Just been to speak to him, the man charged him £230 for the work.

He asked for a cert so he is dropping one around in the morning??

Also I looked again in the electric cupboard where the meter is and the 100a isolator, it looks like he has cut the main Earth coming from the western power supply and put it in a connector block, then taken a new 10mm earth to the 100a isolator so he has an earth there for his 2.5 twin and earth cable to supply the shed. I've read that the main Earth can't be cut and should be continuous??

The MET can be positioned as you describe, but post a picture for clarity
 
IMG_7581.JPG
IMG_7582.JPG
IMG_7588.JPG
 
Good pictures, but think Murdoch said it all in 2 small words.

No seals on the service head ?

So he's cut the Earth and used an ordinary connector wrapped in tape ?.
 
Last edited by a moderator:
Yeah it looks like he has done that. I'm not even sure if he has used a connector block, I haven't touched it to take the tape off!

Does the main incoming earth need to be continuous? With no joints etc
 
What's with the red tape on the Live outgoing conductor? also ruined the IP rating of the isolator.
 
The warning notice did a lot of good. Get your mate to get a competent electrician in, even if it's just to disconnect that mess.

PS; the 'tails' to the CU look a bit suspect as well. Nicely fashioned hole for them as well.
 
@Jacko If he was going to cut into the Earth like that, he should have used a proper block to make the connection. But with the way everything else has been done, it's only to be expected.
That 2.5 has no protection at all, so in the event of a fault the cable may well fry.
There's no RCD protection so in the event of someone touching something that has become live, basically they're going to get Electrocuted. (Read as: Likely DEAD).

One of the boys asked where he'd left his horse, to be honest I wouldn't insult Cowboy's by calling him one.
 
Last edited by a moderator:

Reply to Garage electrics help needed please in the UK Electrical Forum area at ElectriciansForums.net

Similar Threads

Hi all, New to the forum. I have been asked to look at this for one of our guys who's had an issue onsite after some electrical works had been...
Replies
4
Views
742
Hi there, long time lurker, first time poster here. Straight down to it.. A friend asked me to add some sockets and additional lights to a small...
Replies
0
Views
888
Hi, I’m new to the forum and am seeking some advice please. I’ve picked up a job that another electrician has abandoned, the job is to...
Replies
17
Views
2K
Guidance please - C&G L3 electrical installation - Hotel extension project Hi folks, I am fairly new to this forum but it looks like the...
Replies
6
Views
693
Howdy, I'm looking for help with my plan to install an extra internal double socket and an external double waterproof socket to my garage. I...
Replies
0
Views
1K

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

Electrical Forum

Welcome to the Electrical Forum at ElectriciansForums.net. The friendliest electrical forum online. General electrical questions and answers can be found in the electrical forum.
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock