dodger421

-
Arms
Supporter
A very daft question from someone who doesn’t crawl around under houses for a living.

Our shower pump has failed and needs replacing, it’s buried underneath the floor and rather than lifting Lino/plywood and/or laminate flooring I’ve lifted the carpet in the spare room and cut a hatch in the floor intending to crawl along to the shower pump.

There’s a short brick wall running the length of the house with no access holes in it (pictured) and which stops me getting to the location of the pump. Can I knock some bricks out to make an access hole between two joists or is that verboten?
 

Attachments

  • 7BCE156F-8E6D-44DF-A9AD-5211CB3632BE.jpeg
    7BCE156F-8E6D-44DF-A9AD-5211CB3632BE.jpeg
    514.1 KB · Views: 207
Excuse me if I am being stupid, but are you sure it is under the floor? I assume you looked behind the bath panel? More times than not a shower pump is mounted under the bath.
Wouldn’t that be nice? When we moved in I did think that, and even got all excited when I took the bath panel off to see a pump. Sadly that turned out to be the pump for the water jets in the bath.

I vainly hoped it might turn out to be in the loft, after all there were two 22mm pipes with ball valves just inside the loft hatch and roughly where the shower is. Moving aside the copious new itchypoo revealed they were in fact stop-ended after the valves.

The only place left was underneath the floor, and sure enough that’s where I found the bloody thing. Buried, inaccessible and leaking like a sod.

Thankfully the sub-floor is concrete above the DPM, so it should dry out quickly.


The honeycomb walls are for ventilation of the suspended floor space to prevent rot, there should also be air bricks in the outside walls on both sides to provide through ventilation, the underside of the floor was never meant to be accessible, but sometimes hatch's where provided if electrical cable's where run in the underfloor space, but very rare in that age of building, only when modern electricians got involved did floors get butchered, electrics where in conduit from drops from the ceiling.
Thanks Mike, I knew it was for ventilation and sure enough the air bricks are all present and unrestricted (good chance to check while I’m under there). I was surprised the north/south wall wasn’t honeycombed too given that it’s all one house, but it’ll have a hole in it soon enough so I can get through to the rest of the house for a rewire.
 
The picture brings back memories as me as a skinny 16 year old apprentice getting under the floors...

I could fit in that space with only 2 rows of bricks... just couldnt breath out unless my chest was between joists
Yes me too skinny 16 years old apprentice, no chance these days, mind you some of the big old houses in London, the voids were massive could nearly stand up and walk around the whole area with the brick piers like statues.
 

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Green 2 Go Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses Heating 2 Go
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

Advert

Daily, weekly or monthly email

Thread starter

dodger421

Arms
Supporter
-
Joined
Location
Scotland
If you're a qualified, trainee, or retired electrician - Which country is it that your work will be / is / was aimed at?
United Kingdom
What type of forum member are you?
Practising Electrician (Qualified - Domestic or Commercial etc)

Thread Information

Title
Knock a hole in A Sub-Floor Wall?
Prefix
N/A
Forum
UK Electrical Forum
Start date
Last reply date
Replies
17
Unsolved
--

Advert

Thread statistics

Created
dodger421,
Last reply from
7029 dave,
Replies
17
Views
4,741

Advert

Back
Top