OP
The Ghost
Did not test Ra, just wanted to change sockets and get council to check basically.the Ra
Discuss Looking for opinion on whether this scenario is compliant in the UK Electrical Forum area at ElectriciansForums.net
Did not test Ra, just wanted to change sockets and get council to check basically.the Ra
If it is anything like the rods I have measured the last few weeks then the readings will be much higher than normal.What is the Ra valie?
Wrong..... if you look below table 41.1, it specifically mentions RCDs.That’s for over current protective device disconnection not RCDs.
But if you rely on an RCD for fault protection you must ensure the fault currents are significantly higher than the rated residual current of the RCD.Wrong..... if you look below table 41.1, it specifically mentions RCDs.
Using a 30mA RCD for earth fault protection then your maximum permitted Zs is 1667 ohms.Ok so still, 11.7 ohms Zs on RFC any thoughts? 60898 MCB 32a B
Reply to Looking for opinion on whether this scenario is compliant in the UK Electrical Forum area at ElectriciansForums.net
We get it, advertisements are annoying!
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.