OisinMurray
DIY
- Reaction score
- 0
Hi All.
I am retrofitting seats into my Subaru Impreza, from a legacy. The new seats are electric and were working fine coming out of the doner car.
There was an existing unused wire under my seats so I connected that to the new seats. Its showing that there is 10v getting to the connection on the seat but nothing happens when I try adjust them.
When I do try adjust the seat the voltage drops from 10v to 0v? What would this issue be? Perhaps the wires arent being supplied enough power for the electric seats? (Existing wire in the impreza is smaller than the one that was used in the legacy)
I'm a little lost on where I should look too for trouble shooting!
I am retrofitting seats into my Subaru Impreza, from a legacy. The new seats are electric and were working fine coming out of the doner car.
There was an existing unused wire under my seats so I connected that to the new seats. Its showing that there is 10v getting to the connection on the seat but nothing happens when I try adjust them.
When I do try adjust the seat the voltage drops from 10v to 0v? What would this issue be? Perhaps the wires arent being supplied enough power for the electric seats? (Existing wire in the impreza is smaller than the one that was used in the legacy)
I'm a little lost on where I should look too for trouble shooting!