I’m looking to buy a Conduit Bender. Does this come with everything:
https://www.ebay.co.uk/itm/235247610872?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=T2ZWK9XSSa6&sssrc=4429486&ssuid=-hh-nLs6TQy&var=&widget_ver=artemis&media=COPY
I’m an electrician trainee and very new to conduit bending.
So the length of the floating wood is 9 1/2” and the height is 10 3/4”
I’m doing a 30 degree bend with multiplier of 2.
I marked the first mark at 9 1/2” then from that mark I measured 21 2/4”, but it just passes to far from the...
Hello.
Is it allowed to turn a 1.3" (34mm) thick 4-core (neutral and 3 phase) cable that is 7" (18cm) long, including outer insulation, at the exit from the wall by 90° like a clock hand?
If the insulations are too stiff, I could heat the piece of cable with a hair dryer.
This black cable is...
Would anyone be able to recommend a good 25mm bending spring. I assume there is a difference between say a Marshall Tufflex and a Tower one from Screwfix?
A real dumb question;
The cable manufacturer has shown 4D as minimum bending radius of the cable in the datasheet. With this information how can I verify my installation? That is whether I would need any support frame for my Junction box (a big box with bus bar in it) to increase the height of...
How would you guys to bend pvc conduit 20mm&25mm with spring to create 3 saddle bend or four saddle bend? Not like a simple 90 degree bends. Is there any formula or tricks or any steps you guys would do? Because I used the app to calculate the distance to bend but end up too close each bend and...
Looking for writen guide to bending Conduit.
All conduit bending guidance seems to be done through word of mouth.
Looking for a writen guide even if ancient
There must be something writen down with guidelines, angles etc. There seem to be US guides but nothing for the UK.
Thanks.
wondering what’s being taught in college these days,to the apprentices.
Cause when they come on site,they certainly aint being taught like us seniors were.
Eg stripping of conductors,many use pliers or side cutters,they do not bend conductors over,up to 2.5mm.
Conduit skills to be admired from...
Iv used this bender for allot of 20mm galv jobs and its worked fine. Im currently doing a job that involves 25mm galv conduit so iv changed the former and steppes up the roller and arm into the appropriate holes. Every bend i do the conduit keeps showing small wrinkles at the start of the bend...
Been helping a friend put some conduit up today to run cat5e and phone cable down to the shed/office in his garden.
His son is doing a plumbing course at college and was keen to help with the conduit and bending,
His method of putting an off set into the conduit was to get a butane torch and...
Bending Springs for plastic conduit someone once said to me that you should tie on end loop and bring through spring it stops it deforming when pulled out.
Is there such a thing as a pvc conduit bender. I thought they would be a simpler way than just bending it with the knee, plus it is frustratung having
Pull out my knee pad to do it.
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.