Appendix 15 – page 362 of BRB says “An unfused spur may be connected to the origin of the circuit in the distribution board”. Like wise can we spur off from a lighting circuit at the DB (MCB 6A) to power a door chime circuit, i.e., two live 1.5 mm cables coming off a 6A MCB? Does this comply or...
Hi all,
installed a door bell, transformer and chime. Door bell on front door, ran door bell cable on outside of house (7m), underground in conduit (2m), through garage (7m (near power cable)), through conduit with power cable (4m), into summer house (4m), connectectd to chime and then...
philip01
Thread
bell
cable
chime
door
issues
power
through
twisted
hi every one
new build we done about 6 months ago, had a call to say that the door bell does ding but doesnt dong.... called in today, the chime is 8 - 16v got a 8v tranny which actually gives 10.5v. when push button is pressed the voltage drops to 7.9v but the ding just doesnt sound right...
hello all i am new on here, today i went to install an extra chime on an existing doorbell in a b&b, with the new chime connected the 2 chimes wasnt working properly, so assuming it must be the transformer wasnt up to it, i rang 2 suppliers to see if there was a higher rated tranny and both told...
Hello.
Could anyone enlighten me as to how these bell transformers are wired into a CU?
Many thanks
https://www.electriciansforums.net/attachments/wylexmts81-pdf.120119/
been asked to wire in a mains door bell, would I take 1 mm from fuse box to transformer, then wire in bell wire from there to switch then back to door chime.
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc