dedicated

Recent contents Top users
  1. L

    UF Heating dedicated pump switching.....

    Is it OK to wire a dedicated UF heating pump to the switch live from the programmer to the Zone valve (usually brown) as I can't use the switch live to the boiler (usually orange) or it will fire up other zones when not required. I am worried about pump operating slightly before the UF heating...
  2. R

    Steam Bath Shower

    Good evening. This is my first post and apologize for my grammar. I need to wire a steam bath shower which has 3500w max 16amp. I know that i need to use rubber 2.5mm cable but not sure what spur i should install. Can i put this on ring circuit ? Many thank for replies.
  3. M

    Dedicated ring final used to serve heating panels ?

    Afternoon, here's the proposed setup I am planning to supply 9 off 600w IR heating panels from a ring final circuit the installation is commercial and the panels will be fitted to a suspended ceiling a contractor and thermostat will control the heaters the circuit is fed from a 32a rcbo in...
  4. tazz

    Building Maintenance Company or Dedicated Fire Alarm Company..?

    This is old Haes panel, installed in a council special needs learning centre, and maintained by a blue chip all building maintenance company. For the past 3 years they have serviced it every quarter, and given it a full bill of health certification. On working on a building extension, we checked...
  5. R

    Core drill purchase

    Would appreciate some advice on this please. Got a contract starting next month rewiring 200 kitchens within a chalet complex. They require 6" extractor fans to be core cut through the concrete structure roughly 350mm in depth. I am looking at buying a dedicated core drill to do this. What...
  6. cprfenom

    immersion on a non dedicated radial

    I went to a job that the owner felt was a bodged job. It was basically a radial circuit wired at the start in 4.0mm T&E, and then it goes to a few sockets that is supplying a washing machine and tumble drier. From there it goes upstairs to the airing cupboard where it feeds a single switched...
  7. E

    Dedicated 32a2.5mm rfc for underfloor heating

    Hello all, doing rewire at the moment and i have pit underfloor heating on dedicated ring to save cable. No reason why not right? Conductors in parallel and all that. Not using fcu's just using stat as DP isolator. 7 zones/stats. Design current ok with Ref method B. Am I doing the right...
    • Eddiesparks
    • Thread
    • conductors dedicated heating parallel rfc right underfloor underfloor heating unless using
    • Replies: 1
    • Forum: UK Electrical Forum
  8. electrosparks

    smoke detection/rcbo yes or no

    HI SPARKYS JUST A QUICK BIT OF ADVICE REQUIRED. HAVE RECENTLY BEEN TO PRICE A DB CHANGE OF THE DUAL SPLIT LOAD VARIETY.and noticed the instal has a dedicated smoke detection circuit .Now i have also noticed that this circuit is buried in plaster (through a safe zone) and in fact all circuits...
  9. N

    Warm Up Underfloor Heating

    Hi Guys im quoting for a job which has three different areas of underfloor heating all being the Warm up manufacturer , to be honest I have never fitted the stuff , from what I can gather the draw isn't huge and looks fine to run from the existing ring main , however one of the areas is...
  10. T

    safety cluth drill for core cutting

    best ones ? decent priced core cutters also anyone know of any for 4" holes prob 115mm core
    • thelondonway
    • Thread
    • cutting dedicated drill safety still
    • Replies: 8
    • Forum: UK Electrical Forum
  11. U

    EICR + Heat detector Query

    Hi these are two separate queries, First off, What are the minimum requirements for someone to carry out an EICR. I thought it was this and that but basically someone told me that you dont really need anything, just competence which can be ascertained by basic things i.e. ecs card no? I...
  12. G

    Dedicated sub forum for forum advertisers

    How about a dedicated sub forum for forum advertisers? I've seen many forums that rely on forum advertisers have a sub forum with each advertiser having their own dedicated thread. From there they can advertise any offers or answer any specific questions. Just an idea..... :)
  13. P

    Spurring of Shower isolator.

    Really screwed for access here. Can I spur a socket off of a shower switch? Would I have to put a 13A fuswed spur inbetween? Cheers now!
  14. N

    Dedicated circuit for boiler

    Hi everybody Could someone clarify for me please what section / regs of BS7671 ( or if any other building regs etc) states that we should run a dedicated circuit to boilers OR what is the reason behind it. Appendix 15 of BS7671 states immersion heater/space heater and loads...
  15. D

    Pros & Cons of splitting incoming tails instead of using CU dedicated feed ?

    Just wondering if some of the experts thought there were definite advantages & disadvantages of splitting the incoming tails using a Henley Block etc and supplying a separate dedicated supply to the PV system as opposed to simply using a dedicated MCB/spur within the CU ??
  16. B

    dedicated fuse spur for stairlift

    Hi What is the legal requirments for earthing arrangements. I have been asked to install fuse spur units at top of stairs for stairlift chargers around 2 amps. I have done some survey work and most of the properties are very old some with very old wooden db often with bs3036 fuses and...
  17. P

    Retro fitting of dedicated fuse on main "board" (4 flat conversion)

    Folks I previously had this under the theory and regs forum which I suspect was the wrong place for it - apologies for that. I think it's more applicable here. I live on the first floor in a 4 flat conversion late Victorian / Edwardian terraced property in Crystal Palace SE19. Recently, I...
    • paulbriggs
    • Thread
    • aus board conversion dedicated fitting flat fuse main
    • Replies: 0
    • Forum: Australia
  18. P

    Retro fitting of dedicated fuse on main distribution board (4 flat conversion) ?

    All I suspect this was in the wrong section (this one seems to be theory / practice related for trade). Sorry about that - will put in the general section instead. Paul Briggs
  19. K

    dedicated forum members !

    Id just like to say what a great forum this is and have enjoyed being part of it ! ive enjoyed reading the posts and it has some great members with really dedicated members ! Dan, Jason, Lenny, Phil & Mods & for keeping this forum great with more and better policing than part p ! etc etc ! wow...
  20. S

    Dedicated AC circuit?

    Hi We need some advice on the following....... A potential new client has a hefty SWA cable across his field supplying five 6A caravan hook ups. Ideally he would like us to extend it over to his barn (20M) for a 4kWp system therefore avoiding having to install a new cable under ground. I have...

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

YOUR Unread Posts

Tags

advice aus cable circuit course earth electric electrical electrician hello led light lighting lights looking new please question rcd socket supply switch testing training wiring
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Tiling Advice
DIY Forum
Electrical Advice
Tiling Tools
Electrical News
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock