Good Evening All
Does anyone happen to have a copy of the iet wiring regulations 18th Edition bsi 7671 :2018 published june 2018
isbn 978-1-78561-170-4
my son has decided to start his art work for school on 2 pages of my book so they are...
Hi all,
Hopefully picked the right place to post about this..!
I've just completed an EICR and there was a second board mounted to the water cylinder which does both the hot water and heating.
It's in an apartment (I'm assuming every flat will be the same).
I've told the landlord that I need...
So I've just been reading through the electricians guide to the building regulations for my own knowledge and have come across 2 regulations which I need help on clarifying...
page 80 5.5.2 (e) mentions cables should need to withstand a temperature of 170 degrees C.
Q. now why on earth would a...
Are insulated tools necessary if you're not working live? Watching YouTube videos of sparks in America none of them use insulated tools and working on live circuits is apparently an OSHA offense. In the UK the EWR state that:
"
No person shall be engaged in any work activity on or so near any...
I am trying to get a definitive answer to a question regarding the regulations on the installation of downlights.
Could you please tell me under what circumstances it is a legal requirement for fire safe downlights to be fitted rather than ordinary downlights.
I have a top floor flat with...
Looking for advice.
Can you advise the current situation with having minor work carried out., as to regard of certification.,
1. Installation of new shaver point in bathroom. no previous point in bathroom.
2. installation of spot lights in bathroom ceiling to replace pull cord. ( switch...
So wiring in campervans is included within the scope of BS 7671. In a scenario where someone is being paid to build from scratch or modify a system, is there a minimum level of qualification required by law?
Would a "Part P NICEIC domestic installer" be appropriate to carry out and certify the...
I have recently restored an ancient anglepoise lamp which is not a product as far as I can tell from the well known anglepoise lamp company.
it is fitted with 2 core wiring which is in good condition. As the lamp is in good condition and the only item which I have replaced is a switched brass...
I was wondering, are BS88 fuse boards still used on some new installations especially industrial and even commercial. And if so would that be ok with the regulations or not because its not retrospective. I know they are quite outdated and its hard to find a electrical wholesaler selling BS88...
A post on a thread by @pc1966 got me pondering (post mentioned the Emma Shaw case), what other electrical accidents, fatalities, near misses that given rise to the regulations changing?
Hi all
I am taking the Niceic Pat course on Monday 3rd August, unless it's cancelled due to the current pandemic I am awaiting an answer.
As it may be postponed I'm loathe to buy new copy of the the 4th edition with the 5th edition being released shortly. Does anyone have a copy they no...
Hi,
Currently rewiring my new house and have accepted that the building inspector wants and extractor fan in the downstairs loo. However I'm struggling to work out what is acceptable in regards to "zones"
There is no shower or bath, but there is a small sink and the toilet.
The extractor...
I’ve recently purchased this book from eBay (possibly the first mistake) I’ve noticed that it doesn’t have the hologram sticker like my other books? Have I bought a fake ?
Hello people,
I'm writing up my NVQ portfolio and have covered the cables required and all the containment except for basket.
I need to refer to BS7671 but cannot find a regulation for basket... any help would be appreciated.
Thanks
433.2.2
The device protecting a conductor against overload may be installed along the run of that conductor if the part of the run between the point where a change occurs (in cross-sectional area, method of installation, type of cable or conductor, or in environmental conditions) and the...
Hello Guys
Hope you are all keeping well and safe in this unprecedented times.
Just wanted some advise please. So Yesterday i had a new radiator installed but the installation required extending pipe work under the stairs near the consumer unit and where the main electric feed into the house...
We have had a rear extension built on our home, and our builder arranged the electrician for the electric work required.
I have established that the Electrician and his helper (apprentice/junior) are from a country to the east of Europe and are not currently registered as UK electricians and do...
What's everyone's take on this? Mandates inspect every 5 years by a QUALIFIED person, whereas EAWR and BS7671 state COMPETENT person.
Obviously it won't stop cowboys but does raise the Competent v Qualified debate...
Good Evening All,
I hope this is the correct forum, please do move if I have my neutral in the live / wires crossed.
Thank you for your help with my HMO query. In return, you may be interested in the draft of The Electrical Safety Standards in the Private Rented Sector (England) Regulations...
Can anyone please, tell me is there any sign of breach of Building Regulations here? My new build has been built with space for a single meter box, however, a second one was installed at a later stage. The latest borescope inspection has revealed that there is no lintel above the second box and...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.