O
Octopus
Been to look at a job today in a council property where there are about 6 flats which are all heated by a communal heating system. Only had a quick glance at the board but couldn't see any obvious equipotential bonding.
So my question is, if you can't bond at gas entry as its in a different "facility" where would you run a bond to? Is it OK to use the nearest point on the heating pipes as there is a run just near the cupboard the CU is in (I'm thinking of the "where practical" comment!)
So my question is, if you can't bond at gas entry as its in a different "facility" where would you run a bond to? Is it OK to use the nearest point on the heating pipes as there is a run just near the cupboard the CU is in (I'm thinking of the "where practical" comment!)