Link between one light fitting and socket circuit?

[richy3333]

More to the point why were you changing a CU when you should have been in church?

Perhaps it's the vicarage he was working in?

 

[telectrix]

if the church has a graveyard, maybe it's a ghost voltage.:49:

 

[7029 dave]

I would isolate, leave the socket circuit disconnected at cu, and do an continuity test from light to said socket circuit to prove, could be doubled up.

 

[uksparks]

Yes the light still works with the sockets fully disconnected at the CU, it's like its just connected for absolutely no reason.

 

[Knobhead]

So you’ve left it like this until next week?

 

[davesparks]

So you’ve left it like this until next week?

Of course he has, don't you remember this from the last time he found a fault on a CU change. I think it was a cable with a hole drilled through it he found and then left live for a while.

 

[Knobhead]

I though this sounded familiar.

 

[HappyHippyDad]

I must of missed that, where does it say that?

2nd to last paragraph in the OP.

 

[HappyHippyDad]

It's just a matter of doing all your tests now UK, interesting though. Look forward to the update :smile5:

 

[123]

Of course he has, don't you remember this from the last time he found a fault on a CU change. I think it was a cable with a hole drilled through it he found and then left live for a while.

Recall that thread, don't know if it's been fixed yet! But the install is safer now with the RCD's and MCB's so all is good apparently!