looking for 3rd party lighting designer

[infinity]

I'm looking for someone to carry out lighting designs, using software, mainly for changing over current lighting for LED, does anyone know if anyone?

I've googled it but not really found anyone.

Any help appreciated.

 

[Darkwood]

Try your wholesaler, many have free designers with the obvious taste that you will use their products...

 

[tazz]

I dont know of any software for conversion, I use the manufactures specification on lux per m sq and max area coverage to design lighting

 

[Paul.M]

Or Tazz. He knows his stuff on this type of thing.

 

[Sintra]

All the big manufacturers will provide a free design service for their products.

 

[tazz]

All the major manufactures will either give quick free design or full info, so the designer can cad it. Its in the interest to help out as much as possible

 

[infinity]

Thanks guys.

I'm importing my LED fittings from China so can't rely on a wholesaler or manufacture as usual. It should be quite a regular thing not a one off so I can't really even get them to do it as they will soon realise in not buying any lights!

 

[Darkwood]

Be weary importing goods especially from china unless you can tie them to a UK based distributer, the warranty is probably worthless and you may find you have a heavy bill on your shoulders if these fail, not saying you haven't done your research but I see this happen all too often just because someone is trying to save a few quid.

 

[amckay]

Agree with dark wood. China's LEDs (well 99% of the cheaper ones) are less than half the wattage specified. Maybe order from a uk based supplier?

 

[Leesparkykent]

Relux any good for what you need?

 

[infinity]

I've ordered some samples already. High bays panels Etc and they are identical the the ones I've been paying 3x the price for. Wattage is also correct as I've measured it. They use the same chips as well, all branded, epistar, bridgelux etc
I suppose all the wholesalers here do is order in from China!
I've seen relux but not sure how difficult it is to use..

 

[netblindpaul]

Thanks guys.

I'm importing my LED fittings from China so can't rely on a wholesaler or manufacture as usual. It should be quite a regular thing not a one off so I can't really even get them to do it as they will soon realise in not buying any lights!

I hope that you have CYA as the importer into the EU for the stuff and have the insurances etc. etc. in place as you will be viewed as the manufacturer and have the responsibility as the manufacturer of the kit you sell in the EU under the LVD etc.

 

[davesparks]

I've ordered some samples already. High bays panels Etc and they are identical the the ones I've been paying 3x the price for. Wattage is also correct as I've measured it. They use the same chips as well, all branded, epistar, bridgelux etc
I suppose all the wholesalers here do is order in from China!
I've seen relux but not sure how difficult it is to use..

Don't be fooled, they always send out good units as samples, them follow them with tat when you place the big orders. This is standard operating practice for them.

Out of interest how did you measure the wattage? Did you also measure the actual light output and the quality of the light?

 

[KennyKen]

My Boss in the UK before I left for Aus, used Lutron based intelligent lighting. Ranging from Dimmers. 0 - 10v Drivers, LED Strips to cold cathode lighting... He knows he's stuff and based in London.

 

[Spoon]

As already mentioned, be careful of cheap stuff. In the past to make sure it was CE complient you could just needed to get the documentation from the manufacturer. Now The importer is always responsible for ensuring product certification and consumer safety compliance when bringing in products. It would simply be too hard for government authorities to enforce compliance in a foreign country – China included. This puts a lot of weight on the importers shoulders.