memera 2000 rcd size vs other makes

[mswesty]

hi
i have to replace the 30ma rcd fitted to the model listed above , my question is does anybody know if a standard wylex n range 80a 30ma rcd fit?
i have one in stock and hope to used it up rather than buy in the mem version.
im talking physical size.
the phase is on the left the same a mem.

cheers mike

 

[RecycleElectron]

Hi,
The Memera 2000 RCD that's on the desk in front of me is 90mm high (terminal end to terminal end) and 25mm from the fixed face of the terminal clamp to the face with the L/N marking if that's any help. I can measure other bits too if reqd!!

 

[mswesty]

hi thanks very much
so to clarify
90h x 25deep at terminals

could you tell me
height
depth of swicth part
width
height of terminal areas?
and does switch part line up with the din rail fixings on the back (if that makes sense)
if possible . itll just save me another vist
cheers

 

[RecycleElectron]

90 high and 25 from the fixed part of the terminal to the face where you put the screwdriver in. The height of the switch part is 45, that should be standard I think, the width is 36, also std (2 modules), the DIN rail sits a couple of mm high rather than exactly aligning with the "switch part", the height of the front step to the terminals is 23 at the top and 22 at the bottom give or take a mm.

 

[Johno]

All mcbs, rcds, etc fit on to a din rail, its whether or not the busbar lines up!