Nice to see him go round with a torque screwdriver after...

[Dustydazzler]

 

[Taylortwocities]

And testing??

 

[Dustydazzler]

And testing??

What’s that ...

 

[Mike Johnson]

Does not look like a torque screwdriver to me? or was that a tongue in cheek comment in the title?

 

[Dustydazzler]

Does not look like a torque screwdriver to me? or was that a tongue in cheek comment in the title?

bit of both

i recognised it was a regular screwdriver , but at least he used his experience to double check the connections The Ole fashion way (the best way Imo)

so many times I have seen guys do a board using an impact driver and just whack the lid straight on without checking the connections

 

[Mike Johnson]

Ah ha a mark one wrist torque driver.?

 

[buzzlightyear]

There must be a invisible testing done..
There. Has for the tougue screw driver. Lol, I just use me arm torque.

 

[Dustydazzler]

Ah ha a mark one wrist torque driver.?

Yep

what mother gave u

 

[Mike Johnson]

@ Buzz but do you use a VDE Pozidriv bit, I have never seen them available for impact drivers.

 

[Midwest]

Not sure thats the best way to tightened terminals, unless the drill driver is set really low.

Wonder when he'll answer the very first question asked on you tube;

mark glowacki22 hours ago
Great looking board . How long would the testing take on a board that size

Seem to remember this company have done the rounds before?

 

[buzzlightyear]

Buzz but do you use a VDE Pozidriv bit, I have never seen them available for impact drivers

Yes I have got one, you can get one look on allybabba you can get one for them. Lol.

 

[7029 dave]

I would never use a impact driver anywhere near a cu, call me old fashioned but it would be with my hand and good old manual screwdriver.

Cutting away those MICC cables was emotional for me. lol

 

[buzzlightyear]

Great looking board . How long would the testing take on a board that size

Testing tick done two minutes.

 

[Baddegg]

Them gloves would’ve driven me up the wall in the first 12 seconds!....he’s gonna have to take it apart again to test?.....neat job though ?

 

[Mike Johnson]

I also have never used an impact driver on a CU, not the right tool IMO, but have to say it was a neat board.

Can't work in gloves either, that's either hand. ?

 

[7029 dave]

That sleeving to me looked just yellow.?

 

[buzzlightyear]

Them gloves would’ve driven me up the wall in the first 12 seconds!....he’s gonna have to take it apart again to test?.....neat job though

Bloody pandsie using gloves morris,
How come it was not in sub titles. Lol.

 

[Mike Johnson]

Just watched it again with sound Arghhh that radio would have driven me mad.

 

[buzzlightyear]

Just watched it again with sound Arghhh that radio would have driven me mad.

Silance is golden can you remember that one.?

 

[buzzlightyear]

Why cut a old board to sick another one on top I bet the new CU would have fitted on.