Apologies if this is the wrong forum thread.
I have installed myself a Texecom veritas alarm system.
it’s either the r8 plus or excel, as it has a shared manual and no mention on the remote control panel.
I initially was trying to change the part set bell delay, but concluded it’s not possible unlike the full set. Is this correct?
Also there is a few other settings I’m not sure about and wanted to check what they were so I know I have it set up correctly.
30 - EOL resistor values
36 - Error tone suspension time (part set delay on rcp)
38 - confirmation time/2nd intruder
Every thing else is pretty self explanatory. Thank you for any help and advice.
all the best
I have installed myself a Texecom veritas alarm system.
it’s either the r8 plus or excel, as it has a shared manual and no mention on the remote control panel.
I initially was trying to change the part set bell delay, but concluded it’s not possible unlike the full set. Is this correct?
Also there is a few other settings I’m not sure about and wanted to check what they were so I know I have it set up correctly.
30 - EOL resistor values
36 - Error tone suspension time (part set delay on rcp)
38 - confirmation time/2nd intruder
Every thing else is pretty self explanatory. Thank you for any help and advice.
all the best