installation

Recent contents Top users
  1. C

    12v Pump Installation Issue

    Hi, I have very little electrical experience and would like a bit of advice. I have a kerosene pump installed in the back of my van. According to the manual, it draws 44a. It's powered by a leisure battery (split charge relay). The issue is, the pump is meant to have a 80L/min flow rate, but...
  2. W

    Nema 14-50 plug installation quote

    I received multiple quotes to install a long run for my electrical outlet NEMA 14-50 for my tesla. The cost is huge $1800 give and take. Basically it will be in the drive way running from the electric panel in the middle of the house to under the floor to the crawlspace (20ft), then under the...
  3. EricMark

    RCD if required and what type, re-solar panel installation?

    I decided to get solar panels, the inverter instructions say one can use type AC, so the existing 14 x RCBO CU seems OK, may be a good idea to fit type A in the future, but if following what is says in wiring matters should have type F for my inverter drive washing machine, as if that will ever...
  4. A

    Installation reference method B

    Hi Guys Is there a reason why installation ref method B (in conduit or trunking on a wall) not listed as an allowed installation method on the maximum cable length charts (table 7.1)? Regards
  5. M

    Extended 6AWG wire for new Level 2 Charger Installation

    I currently have a level 2 Tesla wall connector installed on a 60amp breaker via 6 AWG wiring. I need to switch the wall connector out with a different charger brand. The problem is that the Tesla is hardwired through the top, and the other wall connectors I'm considering are fed through the...
  6. nbooth1983

    Smart switch installation

    I'm trying to replace this standard 2 gand 1 way switch with a smart switch. I've put the both live wires into L in and the switched lives into L1 and L2. This is tripping the breaker though so I'm wondering if anyone can offer any advice on what I'm doing wrong. Thanks in advance!
  7. D

    Ring Video Doorbell Wired Installation Setup 3rd Party Accessories

    Hi, So I ended up with a Ring video wired doorbell instead of a Byron video wired doorbell as B&Q were out of stock (had ordered online) and they gave the Ring one at no extra cost (nice of them). Not what I was after but will have to make and do. I don't really want to fork out and buy the...
  8. J

    Sanity check on plan for CU replacement (MCB to RCBO AFDD)

    I'm planning a replacement for my existing domestic CU and would like to have it sanity checked before I get an electrician involved. The main reason for replacing the whole CU is that I would like to have an additional circuit to the attic which would be isolated from the existing one. Long...
  9. S

    Advice on recent Electric Oven installation

    Hi, I've recently had my broken oven replaced in my flat and I paid for delivery and installation. It was hardwired through an unswitched plate which leads to a fused spur with switch on the wall of the kitchen. Everything seemed fine until I idly glanced through the installation manual. It...
  10. Charlie_Don't_Surf

    Electrical Installation Level 3 Course - Distance Learning?

    Hi, Just wondered if anyone knows whether there is such a thing as a distance learning version of the level 3 (C&G or EAL) Electrical Installation course, but which isn't one of the '8 week wonder' type courses, i.e. is an actual full year of study. As I understand it, the 8 week wonder type...
  11. J

    Ceiling fan installation in newly built home

    I am installing a ceiling fan in a newly built home. The builders have left the wiring for this purpose. In the electrical box on the ceiling I have a black, white, red and green (ground) wire. The ceiling fan has only three wires (black, white & green (ground)) initially I connected black...
  12. S

    Service cut out 80 meters away from the installation. Is it OK and Cable Size

    Hi All, I have a client who is developing a plot of land for a single house. Currently, their 100 amp service cut-out is in a cubicle fed by overhead cable, however, this is in the way of the build. Rather than having the cubicle moved before the build and then again once the build is...
  13. Ericsson

    New connection issues with meter installation

    We had a new supply installed this week. DNO installed new cut out and fuse externally. Meter operator sent his engineer to move the meter in the new position and he refused to after making a big fuss about how my electrician decided to do internally the new installation. He said that the...
  14. V

    PV installation - dedicated circuit, or from sub main board? MCS query

    hi thank you for help in advance have a potential pv installation for a garage roof that is some 60m from the main house (main incomer in the house). Spoke to a napit/mcs worker - he said the pv installation has to be on a dedicated circuit. My interpretation is that a dedicated circuit on the...
  15. S

    Electrical Installation Level 2?

    Evening guys Got an assessment tomorrow to hopefully get onto a Level 2 Installation course at College. Has anyone been to this assessment before? Any tips that anyone can give? Would really appreciate any feedback on the assessment/ what to expect tomorrow and the course. Quite nervous about...
  16. H

    At which point does the consumers installation begin

    Just a Q on my mock test 302 principles also anyone here knows where I can find more mock exam for 302 as I have an exam coming up .
  17. J

    16 amp oven installation

    Good evening, I am new to the forum, and I am after some advice I am looking at buying my son a new oven, but have just noticed that the one I intended buying is a 16 amp oven. I believe his current oven is a hardwired 13 amp version with its own fuse on the fuse board. I am thinking of buying...
  18. F

    Phillips Hue Installation - How can I use the power but not the switch?

    I currently have 2 ceiling lights in my living room that I wish to replace with 2 Phillips Hue lights. The current lights are turned on and off together via a 2 gang switch with the second switch operating the light in the conservatory (which has a Hue bulb) I would like to remove the current...
  19. R

    New solar installation - cable sizing and no cables for battery installation...

    So, I already have solar (an older FITS installation) and it's been particularly successful so I want to extend this. I'd like to do two things at this point. 1) Add more panels in a couple of locations. 2) Add battery storage to provide some backup (power regularly drops for us) but mainly to...
  20. E

    New oven installation... confused about amps/wiring

    Hi all, I replaced my old Electrolux oven which operated with a 13 amp plug. The new Kenwood oven I ordered says a 16 amp (Requires hardwiring to a dedicated circuit) is required (see pictures below). Is it not possible if I just buy a 13 amp plug and do the wiring in the terminal box at the...
Best EV Chargers 2025
Best EV Chargers by Electrical2Go! The official electric vehicle charger supplier.

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Green 2 Go Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses Heating 2 Go
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

Advert

YOUR Unread Posts

Daily, weekly or monthly email

Receive a daily, weekly, or monthly email containing a digest of new and recently updated threads.

Advert

TrueNAS JBOD Storage Server

UK Tiling Forum | Tilers Forums
UK Tiling Forum by Tilers Forums UK
Plumbers Forums | Plumbing Advice | Gas Forum
Electrician Tips from Professional Electricians
JBOD Forums: a forum for JBOD storage server advice
JBOD Suppliers: JBOD Storage Server Supplies
Back
Top