S
Sparkzo
This is my first post so a big thankyou to the founders of the forum...
Just a question on 3 phase MCB's.... When installing a new piece of equipment is their a cut off current where RCD circuits are used... upto 40A for instance...?
I was asked to move a 3 phase socket from one position and onto a different board.
That's easy enough to do but was wondering then as I'm effectively doing a new installation should I change the standard three phase socket to a RCD protected socket / or change the MCB to a 3 phase RCBO ...
Obviously a RCD socket would then cost an extra £200... and the delivery time.... Even though where it was before was fine/ acceptable .... but if tested would probably have a recommendation....
So What to do ?
Thanks In Advance
Just a question on 3 phase MCB's.... When installing a new piece of equipment is their a cut off current where RCD circuits are used... upto 40A for instance...?
I was asked to move a 3 phase socket from one position and onto a different board.
That's easy enough to do but was wondering then as I'm effectively doing a new installation should I change the standard three phase socket to a RCD protected socket / or change the MCB to a 3 phase RCBO ...
Obviously a RCD socket would then cost an extra £200... and the delivery time.... Even though where it was before was fine/ acceptable .... but if tested would probably have a recommendation....
So What to do ?
Thanks In Advance