Oh boy did I just pull a bo-boob. I deleted my post before I got started. Teach me to use a phone but the interwebs is down right now and all I have is the data link on this phone.
So, I have a AMPROBE "AMB-2" that does not show any batt on the scale. I have checked the through hole circuit board and it appears fine. There's no smell of burnt but there is no dcV flowing the fuse though fuse has continuity.
This is a company tool so essentially I have to fix the tool or just purchase my own but $6-700 to me is not for me right now.
Has anyone run into this before?
What did you do to fix it?
Oh yeah newbie here so "hi" and, no I am not an electrician as I applied for a forklift position but was hired as a mill right. AND, yes in the last year it has been a pleasure of bad switches and mag switches blown heaters and a lot of private tears and insanely inside screams.
So thanks in advance.
So, I have a AMPROBE "AMB-2" that does not show any batt on the scale. I have checked the through hole circuit board and it appears fine. There's no smell of burnt but there is no dcV flowing the fuse though fuse has continuity.
This is a company tool so essentially I have to fix the tool or just purchase my own but $6-700 to me is not for me right now.
Has anyone run into this before?
What did you do to fix it?
Oh yeah newbie here so "hi" and, no I am not an electrician as I applied for a forklift position but was hired as a mill right. AND, yes in the last year it has been a pleasure of bad switches and mag switches blown heaters and a lot of private tears and insanely inside screams.
So thanks in advance.
