OP
scanner
various methods, I usually fix 2 x 2 galv / plastic / trunkings under/side/top. bush through to existing knockouts, spacing locknut between
This is the method I have seen countless times and advise to use
Depending on the spacing and quantity of the conduits coming through the top,try and pick these up directly,fit 2x2 galv trunking underneath,drilling holes to suit the pipes and the dist board ,bush and locknut with a locknut between to keep the board and the trunking slightly apart
Hi Wassup + Des 56,
I'm trying to visualize this...
So you're cutting the trunking to use as a plate to keep the integrity of the CU ?
IE. attaching the trunking to the CU using bushes and locknuts to non knock out overlapping holes, then drilling the remaining holes regardless of whether the knockouts come out, as you'll be leaving the conduit / plate in situ.
Also, what's the advantage of keeping the board and trunking slightly apart with the locknut between ?
Thanks a lot,
Al