Discuss Energy saving bulb flashing faintly when switched off in the Electrical Forum area at ElectriciansForums.net

Welcome to ElectriciansForums.net - The American Electrical Advice Forum
Head straight to the main forums to chat by click here:   American Electrical Advice Forum

D

dinsdale

Firstly I am am a DIY'er not an electrician.

Last night I noticed that the energy saving bulb in my landing light was flashing faintly even tough it was witched off..

It is two way switched, one switch on the landing and one in the hall, power feeds the switch on the landing, wiring is done using ceiling roses.

I checked the voltage across live and neutral to the bulb in the ceiling rose with the light switched off, voltage is 30V.

I removed the positive switch wire from the ceiling rose and again check the voltage to the bulb, it was now 3V.

The house was rewired in stages between 1986 and 1988.

I have never come across this before. Has anyone any idea what could be the cause and how best to progress.

I do not wish to call in an electrician until I have investigated the simple possibilities.
 
This is caused by voltages induced into the wiring from adjacent circuits.

Some low energy bulbs are susceptible to this.
This can be fixed in a number of ways
1. Get a lamp from a different manufacturer and try that
2. Check that the lighting circuit has an earth conductor (cpc) and that is( and all the earths) are properly earthed. You can use your multimeter on ohms to test continuity, but please turn off all the power first. That stray voltage could just be a fault..
3. Put an R/C network across the lamp contacts. One of these works pretty good Buy RC Network Contact Suppressor PCB mount 100nF 120R Roxburgh EMC XE1201 online from RS for next day delivery.
4. Stop messing about with low energy lamps and put in a standard GLS lamp.
 
Taylortwocities - Many thanks, I had not thought of induction.
The bulb is a cheap B&Q one, so I will find another make.
The circuit is earthed and test OK on installation . I might have to get an electrician to re-test it.
If the change of bulb does not work I will try the capacitor.
 
You will find the problem to be worse with Philips bulbs
at some of the sheltered accommodations that I work at they have banned Philips bulbs
you will also notice the more energy saving bulbs you have in the house the worse/more noticeable it is
what we advise is to put 1 normal bulb in each circuit (ie 1 upstairs & 1 downstairs in a normal house) this quite often solves the problem - but not always.
it depends on the induced voltage from other circuits.
Hope this is some help
 

Reply to Energy saving bulb flashing faintly when switched off in the Electrical Forum area at ElectriciansForums.net

OFFICIAL SPONSORS

Electrical Goods - Electrical Tools - Brand Names Electrician Courses Green Electrical Goods PCB Way Electrical Goods - Electrical Tools - Brand Names Pushfit Wire Connectors Electric Underfloor Heating Electrician Courses
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc

Electrical Forum

Welcome to the Electrical Forum at ElectriciansForums.net. The friendliest electrical forum online. General electrical questions and answers can be found in the electrical forum.
This website was designed, optimised and is hosted by Untold Media. Operating under the name Untold Media since 2001.
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock