another wet pants strikes again.

[buzzlightyear]

called to a job to day where a customer says their emersion heater not working ,gets to the job ,open the cupboard and a nice unvented cylinder .
now this unvented cylinder has not one but two elements feed from a 2.5 cable the old emersion switch ,but wait on why is there two 3kw on..
now 3X2=6kw , the fuse had blown now ,this system wet pants have put in is a pressurised system ,their is no gas but water feed . now a nice new 6mm feed for both elements .and top it all the gas &water needs bonding has well.

 

[Timbo]

I believe this is installed correctly.

 

[Timbo]

And it is wired correctly, too. I do have G3 certification.
Unlike one I got called out to on Christmas day, high limit cutout not wired, cable entry cover plate removed ( could get finger in beside flex ), and stat wired to off signal so no hope of it heating up!

 

[Corbs]

I believe this is installed correctly.View attachment 47018

Are you sure it to regs

Expansion vessel is isolated from cylinder

 

[Timbo]

Isolator removed prior to insulating pipework.
Nice spot though.