Pass my Assessment

[DuaneMHunt1976]

Right i'm logging off for the night, drinking some Cider stuff and i dont drink

But ive Passed my Assessment with NICEIC, just the guy who checks the Assessment is right next (out of my hands).. been up since 5am for a assessment at 8:30am trying to get ready and nerves
only another 12-14mths till the next one i guess

 

[Richard Burns]

Well Done, the cheque cleared then!!

It will be easier next year and hopefully less stress.

 

[Leesparkykent]

Well done mate.

 

[ruston]

Well done Duane.

 

[HappyHippyDad]

Good on you Duane

Haven't got a clue what you are talking about half the time but I like you :smile5:

 

[northstar]

Well done Duane. What did you have to do for your assessment ?

 

[DuaneMHunt1976]

Well done Duane. What did you have to do for your assessment ?

Just to join NICEIC domestic, so will have to do it again every 12-14mths For life

 

[J.C.E]

What was your job? For d.i or approved?

 

[DuaneMHunt1976]

2nd DB for the Sheds with Ring and Lighting Circuits

as for all the Short hands d.i. i can only guess means Domestic Installer
I studied computers and the amount of short hands in there i gave up remembering them all

Also dont understand all the scops, i have to trust what people say basically


Sorry
What did you have to do for your assessment ?
Mmm you mean what did i have to do in the Test than what for
Zdb (as wanted to know what i would do for a Ze and show him here what i would do and it would of been a Zdb)
Made me do a RCD test so the circuit was off.
Safe Isolation (talking as i did it to show that i was doing it right) Also my lock off is NAFF, i asked if there is any thing better as i could take it off without unlocking it,
r1 r2 and rn
R1+R2 cross over
PFC (so PEFC and PSCC)
Zs on the Lighting circuit
Zs on the Ring.

Think that was all, i just took each question as it came.

 

[J.C.E]

He was happy with you measuring zs and calculating R1+R2?
would of thought he would prefer the other way around

 

[DuaneMHunt1976]

He was happy with you measuring zs and calculating R1+R2?
would of thought he would prefer the other way around

Measured Zs for Ring and Lighting
MEASURED R1+R2, but also Measured r1 r2 rn
i can only guess he wanted to see me do the steps of the Rings and then the cross over.

I didnt say any thing about Calculations, i may of said when measuring the r1 r2 and rn that it would be (r1+r2)/4 = R1+R2

I know i miss read things but a lot of others do on this site as well!!
Im going to stop replying for a bit, because im reading some things a bit wrong tone.

 

[newtothis]

Well done that man !