Personally I would put as much insulation underneath as practical without compromising the wiring or the ventilation.
Much more important to eliminate draughts too.
Not too much heat is lost through the floor, if draughts are excluded, compared to walls windows and roof as heat rises.
Some...
If you discount the throwing across the room bit, I have seen this in the past:
Electric shock on a plastic rocker switch. On further investigation I got 80-100V by putting a multimeter probe on the gap between the toggle and faceplate - to earth. On closer inspection this was full of dark...
Remember the bottom element, off peak, heats the whole tank.
The "boost" top element only heats the top 1/3rd or so of the tank.
So wiring the top element to off peak means the customer runs out of hot water mid morning!!
Heat alone cannot solve the problem.
If you heat the air in a sealed space, it will absorb more moisture. In a bath room the air will soon become saturated. This will then condense on anything below the dew point of that air. That will be everything else in the room not heated up above the...
CDM is more than just health and safety of the moment.....
Also looks at long term issues such as how/is it possible to maintain something long term etc.
So if you install something that cant be maintained for whatever reason.........
Edited to add, still a load of CARP!
I have seen it where a light switch in a kitchen gave a shock in a friends house.
"Usually happens after I have cleaned it"
Turns out cleaning with a more than damp dish cloth.
When I took switch apart the detritus between the rocker and face plate had to be seen to be believed.
Add a little...
Please bear in mind if this is for use in a boat Nav Light, the filament used in old nav lights were specially designed for a pin point source. i.e. the filament is in a straight line up and down not curled round like a domestic lamp.
This is required to ensure the light is only visible through...
That there is a 5 speed reversing fan controller. Used on some of the cheaper ceiling fans. Possibly other tings too.
Possible someone has disconnected the load looking at the missing paint underneath and broken cable clip?
Re: New CDM Regulations will bring extra duties to smaller contractors ECA predicts a
It means it will cost someone lots of money.
You to train and be informed.
The customer, because they always have to pay in the end.
Net resilt, job will be more expensive.
If anyone bothers for smaller jobs!!
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.