Hi Tim would the following from Ebay be suitable for a 2 x 12v in series (24v) trickle charger left on continuously..https://www.ebay.co.uk/itm/385045991662?hash=item59a68790ee:g:TagAAOSwD3Bi7gsI
Tim thank you
That's something I had not even considered and it sounds a good option.
You say a trickle charger is that something I can look at on Ebay, are they at reasonable (low) cost level.
I am also assuming connect the trickle charger to the 2 x batteries and leave it switched on long...
I need to long term store a Acorn 130 stairlift carriage with internal batteries that is removed from the rail.
The carriage normally picks up electrical charge to the 2 x 13v sealed batteries via 2 x contacts normally acting on 2 x charging points on the rail; one at the rail top and the other...
Got it.
If the switch is under spec I will change it.
BUT if I use only one 2.2kw motor at a time which shows 12.5A on the plate is the isolator switch spec at 20A not sufficient ??
Richard
Hi Telectrix
Thanks for your input.
Specs for switch is:
ROTARY ISOLATOR SWITCH 4 pole PV IP65 20 Amp Lockable TP&N Load break Insulated
BTW albeit the machine has 3 x separate 2.2kw motors only one will be used at any one time.
I am not sure I understand your answer.
I 'thought' I would be...
Hello and thank you to all who helped at post ID http://www.electriciansforums.co.uk/diy-electrical-advice/98241-grey-haired-sawdust-maker-needs-hand.html
I am replacing the Mains In and Supply Out isolator switch and would welcome knowing what terminals to use.
Setup is 240v 1ph running 2.2kw...
Thank you both for your help.
I think the cable being used is 2mm; it seems to be so when I measure it.
It is a protected impact resistance cable.
There is no marking on the cable showing any specs.
Maximum single run in clear air length is 5ft (1.5m??)
I attach a picture of the cable showing...
Hi
I have today joined this active forum to get answers for electrical matters related to a 1947 Dominion 12" Super Elliot Woodworker.
Prior to my ownership the machine was converted from its original 3ph single motor with multi belt configuration to 3 x 1ph separate motors.
I am enjoying...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc