Looking for a Deep Sea Electronics DSE808 programming interface, to setup a DSE530 genset controller, for purchase or hire.
https://www.deepseaelectronics.com/genset/expansion-modules/dse808/downloads/datasheet/654
It's a now obsolete, RS232 based active cable.
Hi All,
During my exercises on paper, we always assume the source from grid has Tension and Currentnin phase.
Today, for the first time, I was learning about Diesel Genset and noticed its plate saying 2700 MVA / 2000 MW. So basically, somehow a source has its own Power Factor (PF).
1. Can...
Hi.
excuse my ignorance. I have seen this before. Why is the phase in this picture taken through two of the poles in this manner?
the isolator is wired in exactly the same way with the phase going through line contact out the top and back through another pole.
what am i missing please...
Hi,
So I am currently troubleshooting a cummins generator that only seems to be able to switch from idle and rated speed mode during only after running for about ten minutes, any longer than that everytime i switch back to idle from running, there is no change and when i change it back to...
I have a 30 kw Genset, why when turned on, do not read volts on a volt meter. but the voltage read, after I shift the change over switch on the generator line.
genset: toyota dyna engine, 30 kw 3 phase alternator
Hi friends
i have some difficult comments for my selection of generator for one of my client..
i ll give the details here
i have a main panel at 462kw to be fed with a generator
connected load = 462kw
diversified load = 371kw (made from detailed calculation of all the feeders)
spare...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.