OK, have had a play. Easy enough to use even for a DIY'er / beginner. It's obvious when you have an open circuit through to a dead short. The interesting bit is the in between with a wire in various states of manglendness.
As the voltage ramps up then down, the display will jump around showing...
I went for this in the end, as it was on offer and looked well put together.
Here is the link (although different colours to the one I was sent): https://cpc.farnell.com/tenma/ten01053/insulation-tester/dp/IN05462?CMP=TREML007-005
I have seen a lot of the exact same units with different...
I have an SWA cable running from the CU to the garden that the previous owners had fitted, but no longer worked when I moved in a few years ago, that I want to reinstate.
The cable itself runs from the kitchen where the CU is and is then buried under the floor, under the utility room and shower...
I know this is an old thread but I am looking for a single socket that has a built in fuse, with the socket drawing power from the load side. I am un-bodging some previous owner DIY's electrics, where they have spured off the ring and then spured again.
I cant finding anything after a Google...
Hi, just saying hello. DIY'er here (boo!), been sorting out some horror shows in the house, but always looking to do the right thing, unlike the last occupant :eek:
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.