Can dry line socket back boxes be mounted back to back in a stud wall if its deep enough?
And if so do they need to have the fire seal installed?
I doubt the walls not a fire barrier as it only just goes up pasted the false ceiling but it is still fitted with fire rate double plaster board
I know this is going to cause madness but how would this work exporting the earth is driving me nuts i feel like its a hard one to understand
for example a house has a tncs and it supplies a metal shed that is a TT system so the earth has not been exported.
the shed is 30m from the house
the...
I know fire rated downlights are installed in false or suspended ceilings as the normal as the cost difference is small...
But what about PIR sensor in a false ceiling or a suspended grid ceiling wouldn't they need to be fire rated if it was a fire rated ceiling?
this is the panel 12 of the 23w MODLED LG - High performance backlit module with VDT optic | Tamlite Lighting United Kingdom - https://www.tamlite.co.uk/product/modled-lg but i cant seem to find much info on it?
Does any one have a rough idea how many 24w led panel 600x600 could go on a 10 amp type b rcbo with out tripping or a 6 amp type B rcbo
I found a long circuit that complies with zs when a direct measurement is taken at its furthest point , but on length alone im sure it does not comply by...
Its how one of the buildings I have been in was done, but it was only like that in the corridors in all the rooms it was marshall boxs
I think it looks like it was done like that as the ceiling above the false ceiling is slanted made of metal and about 2 section of a tower above the false ceiling?
Thanks for the replies everyone, had covid related issues so i wasn't able to reply 0.o
a little off topic but it goes along with the design off a lighting circuit would this be an acceptable way to run a circuit ? using something like this...
So for my example circuit I calculated the VD from the origin of the circuit but then after the switch only the current drawn down the switched live...
But what about the current the permanent live would draw at every other light for its emergency fitting
Would that need to be calculated as...
Okay what if you run 3 core and earth from the switch to light led on the circuit as half of the lights were emergency lights. so you had a SL and a PL at every point? the onsite guide on shows two core and earth?
would it double your cable legnth?
would that change your volt drop or would it...
i rounded because i was lazy 8)
Ah thank you I get it now :D
I also realised if you are using LED lights its going to be pretty hard to exceed VD if the loads are distributed .
for electronic loads how would you be able to find out the unity power factor?
1594843736
I looked at the on site...
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.