how to remove a pir.

[john102956]

Hello. Could anyone tell me how to remove this type of pir on an optima xm6 system. As shown in the attachment the pir has a hole underneath the cover. However, when checking this there appears to be no screw to release and remove the front cover . The pir appears to be attached to a bracket at the back. No screws showing at the back either. In the event i need to replace one of these is anyone familiar with it. How do you open the cover and remove it when replacing a faulty pir. Guessing, i think you either pull the body off the bracket which appears to be inserted in the back and is fixed to the ceiling or lever the front cover off with a screwdriver. I don't know the make as it is quite old. Anyone recognise it?

 

[DPG]

Remove the screw at the bottom and lift the front cover away.

 

[DefyG]

But will activate the tamper circuit and main sounder

 

[loz2754]

The bottom screw looks like it's missing. In that case it should be easy to pry the cover off.

 

[DPG]

But will activate the tamper circuit and main sounder

True, but it seemed like he was asking from a mechanical point of view.

 

[telectrix]

Texecom is the make. small slotted driver in the bottom joint and twist. then code in panel/keypad to silence tamper alarm.

N.B. the PIR cover hooks on tabs at the top.