Continuity RFC error??Help please

[buzzlightyear]

tidied up the CU today, any constructive comments + or - ??

yeah ,why is that buss bar half hang out top pic and bottom pic?

 

[Pete999]

tidied up the CU today, any constructive comments + or - ??

View attachment 39756

View attachment 39757

Cable entries are a bit rough, no grommets, not sure about the IP rates on the side, and the bottom internal could do with a clean, plus not keen on the curls made in the Live Brown conductors

 

[Gudoldtom]

Cable entries are a bit rough, no grommets, not sure about the IP rates on the side, and the bottom internal could do with a clean, plus not keen on the curls made in the Live Brown conductors

Cool thanks. bottom picture is before top is after. I just used the existing 10 year old wiring & CU already installed I should have bought some grommets though. I did clean the bottom tray. I don't think I did too bad for a first time touching a CU. Thanks for the comments though.

 

[Octopus]

Ditch the Wylex MCB and get a Crabtree... or more sensible to fit a blank for unused "ways"

Whats the labelling like on the cover?

 

[buzzlightyear]

Ditch the Wylex MCB and get a Crabtree

one of these !

 

[telectrix]

Cool thanks. bottom picture is before top is after. I just used the existing 10 year old wiring & CU already installed I should have bought some grommets though. I did clean the bottom tray. I don't think I did too bad for a first time touching a CU. Thanks for the comments though.

fair play to you there. it's better than a lot that i've seen.

 

[123]

The right hand side busbar in the after pic is not on correctly.

And as said, ditch the Wylex MCB and fit a blank

 

[Des 56]

You need to work on those bus bars,they look a mess,straighten the left hand mcbs out and no doubt it may then sit correctly

Try dressing cables with more acute bends and don't try to get to the connections too quick,more bends needed rather than untidy sweeps

Finally,ditch those pig tails they are an eyesore, then get hold of a Hoover

 

[Madocks]

They emailed me the guide same day thanks for the advise

Did you find it handy ?

 

[elsparko]

sort out the bussbar and its better than it was originally , better than alot ive seen

got a board change tomorrow, my favourite , sit in one place for half a day? suits me fine (3 boards into 1) before any wise ones slip in how they do boards in 2 hours.

the more you do the better you get, work from the furthest end of the board from your cable entries to keep it tidy as you work, same applies for running cables on tray and basket, start at the furthest point so cables arent crossing over