P
petef ordham
Hi I'm new to this forum and there looks to be plenty of knowledge on her so here goes!
Basically I am an experienced independent vehicle repairer though with limited knowledge of vehicle canbus systems just a basic understanding..
Vehicle Mazda 2 auto easytronic with just 19k miles 2006 early shape. Same auto box as Ford Fiesta, fusion etc.
Non start so owner decides to jump start but puts leads on wrong way around putting 24 v through system. We only get the non start message over the phone but auto clutch actuator is suspected. Plugged in diag interface on arrival will not power up - no bat live feed on diagnostic port terminal 16. No power to radio abs warning light on, charge light, no central locking, transmission fault light on, all found after managing to start engine direct wiring to starter solenoid. ECU tested out fine by specialist changed one blown ecu fuse all others including main fuses all good. No idea where each module is on the vehicle and need some guidance or help with the best way to go with this as I have reached the end of my knowledge and knowhow. Thanks.
Basically I am an experienced independent vehicle repairer though with limited knowledge of vehicle canbus systems just a basic understanding..
Vehicle Mazda 2 auto easytronic with just 19k miles 2006 early shape. Same auto box as Ford Fiesta, fusion etc.
Non start so owner decides to jump start but puts leads on wrong way around putting 24 v through system. We only get the non start message over the phone but auto clutch actuator is suspected. Plugged in diag interface on arrival will not power up - no bat live feed on diagnostic port terminal 16. No power to radio abs warning light on, charge light, no central locking, transmission fault light on, all found after managing to start engine direct wiring to starter solenoid. ECU tested out fine by specialist changed one blown ecu fuse all others including main fuses all good. No idea where each module is on the vehicle and need some guidance or help with the best way to go with this as I have reached the end of my knowledge and knowhow. Thanks.