Fire alarms and certification

[davek]

Hi all
I have been contacted by a hairdressers who needs a few sockets an light switchs moving due to knocking wall down. But also there is a fire alarm panel, alarm button, and a siren to move. The panel is a mag4 wired with fp200. I will need to disconnect cables as they run through a door case to panel. any advice on this panel and regards to testing and certification etc.
Regards
Dave

 

[tazz]

Standard conventional panel...power down fully, install new cable routes, without jointing. The Test and commission the complete system, making sure any alterations to the building are still cover by detection. Test/commissioning and handover certs need to be issued.