- Reaction score
- 1,694
The biggest problem I find is the L shaped lip on the edge of enclosure to give them strength. This means getting square on to a wafer thin locknut is virtually impossible unless using a cranked spanner or socket if the cable isn't already in the gland. I prefer a spanner or adjustable spanner if possible and slip joint pliers or grips if a spanner isn't working.
I have some Teng adjustable spanners that have slim jaws that are slightly angled that are perfect for locknuts.
Also had some luck with serrated washers under the locknut and tighten from below with a finger on the locknut as you start!
Yes I am guilty of using a cold chisel and small hammer or linesman pliers to tighten up locknuts in the past!
Would I do it now, mmm probably in a pinch yeah, sometimes you just have to work with what you have!
If it's a crowded DB with just enough room in the gland plate for one more, but not enough room to swing a spanner what you going to do?!
I have some Teng adjustable spanners that have slim jaws that are slightly angled that are perfect for locknuts.
Also had some luck with serrated washers under the locknut and tighten from below with a finger on the locknut as you start!
Yes I am guilty of using a cold chisel and small hammer or linesman pliers to tighten up locknuts in the past!
Would I do it now, mmm probably in a pinch yeah, sometimes you just have to work with what you have!
If it's a crowded DB with just enough room in the gland plate for one more, but not enough room to swing a spanner what you going to do?!