Cable size when burying

[craig.jones76]

I have a run of cable where 12% is buried in ducts, the rest is on perforated tray, what are the limits on amount of cable buried when sizing cables?

 

[James]

Cable rating should be adjusted for worst case, if 12% of it is underground that 12% can carry only its de-rated current

 

[pc1966]

What is not clear is what that 12% is. If it were under half a meter under/through a wall on a 5m run then probably thermal effect is small, but if any significant length then you would have to de-rate the CCC to that segment as James said.

 

[craig.jones76]

5m of 40m run , I was looking for a formula or guide value if there is one?

 

[westward10]

5m of 40m run , I was looking for a formula or guide value if there is one?

See Table 4D4A of BS7671.

 

[Electro-tech]

I have a run of cable where 12% is buried in ducts, the rest is on perforated tray, what are the limits on amount of cable buried when sizing cables?

Is the cable installed yet or not? Information of max demand required? The difference between Ref E & Ref D can be quite a lot of derating or larger cable sizing.

 

[craig.jones76]

Is the cable installed yet or not? Information of max demand required? The difference between Ref E & Ref D can be quite a lot of derating or larger cable sizing.

NO it's not installed as yet, just sizing the cable required.
It's a 40M run with 5M under ground

 

[craig.jones76]

Is the cable installed yet or not? Information of max demand required? The difference between Ref E & Ref D can be quite a lot of derating or larger cable sizing.

70mm 3 core x 2 swa

 

[Electro-tech]

As westward10 said ''See Table 4D4A of BS7671.'' Still need to know what type of loads you are expecting to supply.

 

[westward10]

2 × 70.0 three core?
That is unusual as above what is the nature of the supply.