Hi all, looking for some advice. I came to the electrical trade a bit later than most. I started my C&G 2357 (NVQ L3 & AM2) in my early thirties. 3 and a half years at college and passed no problem. The vast majority of my work experience during my time at college was domestic based, with little bits of commercial, but mostly domestic. I've since gone on to obtain my 2391, 18th ed, C&G 2919 Ev charging, IPAF etc and have my JIB Gold card. I've been working for myself for about 3 years now and I'm looking to get away from domestic. Tired of working for letting agents etc in dirty hell holes. I'm looking to get into commercial site work, but my experience is very limited. I haven't really touched metal containment since college or used proper drawings since then (I use kitchen plans etc but that's about it.) Has anyone got any advice on what I could do? Thanks in advance!!
- Sep 5, 2010
- 71,498
- 72,015
- 18,688
- 78
- If you're a qualified, trainee, or retired electrician - Which country is it that your work will be / is / was aimed at?
- United Kingdom
- What type of forum member are you?
- Electrical Engineer (Qualified)
- Business Name
- Telectrix
go for any jobs you fancy. Blag it on the experience. . gold card will get you over the first hurdles
Few people have said that to me, I just hate the thought of going on site and someone asking me to do something,and then looking back at them with a rather blank expression on my face.
Thing is,I'd happily take a cut in money to get I somewhere and be shown the basics again.
D
Dustydazzler
Putting up some tray or running in some galv tube really isn't that difficult. As Tel says a Gold Card will get you on most big sites
I'm even looking on eBay etc for a set of conduit benders so I can start getting some practice in.
- Sep 5, 2010
- 71,498
- 72,015
- 18,688
- 78
- If you're a qualified, trainee, or retired electrician - Which country is it that your work will be / is / was aimed at?
- United Kingdom
- What type of forum member are you?
- Electrical Engineer (Qualified)
- Business Name
- Telectrix
answer to that is that you not done any of "that" for ages, and "is there a more modern way"? as dusty sez, tray is just a bit of metal and some anchors. galv tube a bit more diffy. always rem. that a poorly bent bit of tube can be re-used as a shorter bit. (and there's always a skip handy)
- Sep 5, 2010
- 71,498
- 72,015
- 18,688
- 78
- If you're a qualified, trainee, or retired electrician - Which country is it that your work will be / is / was aimed at?
- United Kingdom
- What type of forum member are you?
- Electrical Engineer (Qualified)
- Business Name
- Telectrix
that's a good idea. when i first went bending i used to bend the tube about 6" longer over what i thought, then cut and thread to fif.
That sounds like something I would definitely do! You can always take off but you can't add on!
D
Dustydazzler
100% this
You can quickly cut off a bit if you are a but long , much more tricky to add an extra bit on
Similar threads
OFFICIAL SPONSORS
These Official Forum Sponsors May Provide Discounts to Regular Forum Members - If you would like to sponsor us then CLICK HERE and post a thread with who you are, and we'll send you some stats etc
