N
nickblake
Dear lighting manufacturers, you do make some very nice lights, but please can you manufacture them so that we can comply with the regulations , we cannot connect a fitting with three single insulated cables connected to a terminal block and wrapped in insulation tape and pushed into the ceiling void , and the amount of space in some of your fittings , well we have to use a minimum of 1mm to connect these fittings they wont fit through a hole thats only 5mm in diameter, and your terminal block sometimes be so small we cant get three cables into that , and why do you put the fixing holes be hind the fixed glass , or have so many small parts that you need to be an octopus with a rocket science degree to assemble ,your screws with no slotes in the heads ,with spring clips that do not hold a fitting in place , and those nice little uplighters that have the fixing holes straight where the cable is in the wall , and why on those down lighters do your terminal covers fall off , those nice little wall lights you have designed for use with out cable because you have left no space for them , and why do you put the cable entry holes right by the lamp , and those little ceramic up lighters can you supply a 25mm long screw driver so we can fix them to the wall , it would be nice for the terminal screws to be the type that actually fit a screw driver , it would be nice if you could see the problems we have installing your lights thank you for listening lighting manufacturers